Search results for " Bioreactors"
showing 10 items of 19 documents
Bacterial Community Structure of an IFAS-MBRs Wastewater Treatment Plant
2017
TIn this work, the bacterial community putatively involved in BNR events of a UCT-MBMBR pilot plant was elucidated by both culture-dependent and metagenomics DNA analyses. The presence of bacterial isolates belonging to Bacillus (in the anoxic compartment) and to Acinetobacter, Stenotrophomonas, Rhodococcus, Escherichia and Aeromonas (in the aerobic compartment) is in agreement with the nitrification/denitrification processes observed in the plant. Moreover, the study of bacterial community structure by NGS revealed a microbial diversity suggesting a biochemical complexity which can be further explored and exploited to improve UCT-MBMBR plant performance.
Mass transfer and hydrodynamic characteristics of unbaffled stirred bio-reactors: Influence of impeller design
2014
Abstract Unbaffled stirred tanks are increasingly recognized as a viable alternative to common baffled tanks for a range of processes where the presence of baffles is undesirable for some reason. For instance, in the case of shear sensitive cell cultivation (e.g. human cells), unbaffled tanks have been recently found to be able to provide sufficient mass transfer through the free surface vortex. As a consequence the need for bubble formation and subsequent bursting, along with relevant cells damage, is conveniently avoided. In this work the influence of impeller geometry on mass transfer performance and power demand of an unbaffled stirred vessel operating both in sub-critical conditions (t…
Nitrous oxide emissions in a membrane bioreactor treating saline wastewater contaminated by hydrocarbons
2016
The joint effect of wastewater salinity and hydrocarbons on nitrous oxide emission was investigated. The membrane bioreactor pilot plant was operated with two phases: i. biomass acclimation by increasing salinity from 10 gNaCl L−1 to 20 gNaCl L−1 (Phase I); ii. hydrocarbons dosing at 20 mg L−1 with a constant salt concentration of 20 gNaCl L−1 (Phase II). The Phase I revealed a relationship between nitrous oxide emissions and salinity. During the end of the Phase I, the activity of nitrifiers started to recover, indicating a partial acclimatization. During the Phase II, the hydrocarbon shock induced a temporary inhibition of the biomass with the suppression of nitrous oxide emissions. The r…
Greenhouse gases from sequential batch membrane bioreactors: A pilot plant case study
2016
Abstract The paper reports the results of nitrous oxide (N 2 O) emissions from aerobic and anoxic tank of a Sequential Batch Membrane Bioreactor (SB-MBR) pilot plant. The influence of salinity variation on N 2 O emission was analyzed by gradually increasing the inlet salt concentration from 0 to 10 g NaCl L −1 . The observed results showed that the N 2 O concentration of the gaseous samples was strongly influenced by the salt concentration. This result was likely related to a worsening of the nitrification activity due to the effect of salinity on autotrophic bacteria. Dissolved oxygen concentration and salinity were found to be the key factors affecting N 2 O concentration in the gaseous s…
Occurrence of Microplastics in Waste Sludge of Wastewater Treatment Plants: Comparison between Membrane Bioreactor (MBR) and Conventional Activated S…
2022
In this study, the presence of microplastics in the sludge of three wastewater treatment plants (WWTPs) was examined. The investigated WWTPs operated based on a conventional activated sludge (CAS) process, with (W1) or without (W2) primary clarification, and a membrane bioreactor process (MBR) (W3). The microplastics (MPs) concentration in the samples of W3 was approximately 81.1 ± 4.2 × 103 particles/kg dry sludge, whereas MPs concentrations in W1 and W2 were 46.0 ± 14.8 × 103 particles/kg dry sludge and 36.0 ± 5.2 × 103 particles/kg dry sludge, respectively. Moreover, MPs mainly consisted of fragments (66–68%) in the CAS plants, whereas the fra…
Wastewater treatment and reclamation : A review of pulp and paper industry practices and opportunities
2016
The pulp and paper (P&P) industry worldwide has achieved substantial progress in treating both process water and wastewater, thus limiting the discharge of pollutants to receiving waters. This review covers a variety of wastewater treatment methods, which provide P&P companies with cost-effective ways to limit the release of biological or chemical oxygen demand, toxicity, solids, color, and other indicators of pollutant load. Conventional wastewater treatment systems, often comprising primary clarification followed by activated sludge processes, have been widely implemented in the P&P industry. Higher levels of pollutant removal can be achieved by supplementary treatments, which…
Design of perfusion bioreactors and PLLA-based scaffolds for in vitro tissue engineering
2022
L'ingegneria tissutale rappresenta un nuovo approccio che integra cellule e matrici ingegnerizzate per la formazione di nuovi tessuti. In questa strategia, tre componenti essenziali costituiscono la cosiddetta triade della Tissue Engineering: segnali regolatori, cellule e scaffold tridimensionali (3D) biodegradabili e porosi. Tali elementi sono combinati per sviluppare un tessuto funzionale organizzato e 3D che simula la matrice extracellulare (ECM) del tessuto da rigenerare. Le funzioni specifiche dei tessuti nativi sono correlate agli ambienti complessi che, all'esterno del corpo, possono essere imitati usando degli strumenti chiamati bioreattori. Questi sistemi forniscono un ambiente in …
Sensitivity and uncertainty analysis of an integrated membrane bioreactor model
2015
Sensitivity and uncertainty analysis, although can be of primarily importance in mathematical modelling approaches, are scarcely applied in the field of membrane bioreactor (MBR). An integrated mathematical model for MBR is applied with the final aim to pin down sources of uncertainty in MBR modelling. The uncertainty analysis has been performed combining global sensitivity analysis (GSA) with the generalized likelihood uncertainty estimation (GLUE). The model and methodology were applied to a University Cape Town pilot plant. Results show that the complexity of the modelled processes and the propagation effect from the influent to the effluent increase the uncertainty of the model predicti…
Nitrous oxide from moving bed based integrated fixed film activated sludge membrane bioreactors
2017
Abstract The present paper reports the results of a nitrous oxide (N 2 O) production investigation in a moving bed based integrated fixed film activated sludge (IFAS) membrane bioreactor (MBR) pilot plant designed in accordance with the University of Cape Town layout for biological phosphorous removal. Gaseous and liquid samples were collected in order to measure the gaseous as well as the dissolved concentration of N 2 O. Furthermore, the gas flow rate from each reactor was measured and the gas flux was estimated. The results confirmed that the anoxic reactor represents the main source of nitrous oxide production. A significant production of N 2 O was, however, also found in the anaerobic …
Vortex shape in unbaffled stirred vessels: experimental study via digital image analysis
2011
There is a growing interest in using unbaffled stirred tanks for addressing certain processing needs. In this work, digital image analysis coupled with a suitable shadowgraphy-based technique is used to investigate the shape of the free-surface vortex that forms in uncovered unbaffled stirred tanks. The technique is based on back-lighting the vessel and suitably averaging vortex shape over time. Impeller clearance from vessel bottom and tank filling level are varied to investigate their influence on vortex shape. A correlation is finally proposed to fully describe vortex shape also when the vortex encompasses the impeller.